Skip to main content

This page is still under construction

Deep Hole Heads and deep hole Tooling


Deep hole making in metal

Deep hole drilling is the machining of holes with a relatively large depth to diameter ratio, whereas normal drilling techniques produce holes where the depth is rarely more than five times the diameter (5 xD). In deep hole drilling the ratio may reach 150:1, and any hole deeper than ten times the diameter (10 xD) should certainly be considered a deep hole, requiring a specialized drilling technique.

Deep hole drilling can employ various machine set-ups: rotating workpiece, rotating tool, or both tool and workpiece rotating.

Whichever set-up is employed, the basic principles of drilling still apply, and the correct choice of cutting speeds and feeds are still crucial. Satisfactory chip breaking, and removing the chips from the cutting edges without damaging tool or workpiece, is essential.
Gun drilling is capable of producing smaller holes than the Single Tube System (STS), but the STS system is far more productive (4-6 times) and should always be the first choice when possible. The Ejector system is an alternative to STS when drilling smaller batch quantities as it does not require a special machine.

Boring Bars for deep hole machining

Destructing Heads or full size drilling heads

BTA Bore Head - BTA Boring head

Coring heads

Widening heads.

Push boring heads

Pull boring heads.

Pull Boring

Pull Boring Proces can be done on our BTA boring Drilling Machines

Pull boring is being used mainly to have very straight and accurate long holes. The oil is fed similar to BTA drilling or counter boring i.e. through the pressure head. This has guide pads which are supported in the pre-bore, thus producing the enlarged bore on the original axis.

Go to our tooling for Pull Boring

Single-lip gun drills.